Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

A diesel needs fuel under pressure at the injectors, and air in the fuel system stops that. After the fuel has run out, a filter has been changed or the engine has sat for years, the system has to be primed and bled. If air keeps getting back in, there's a leak on the suction side, before the pump.

In this video, on the single-cylinder S195 diesel, I read the manual's starting and bleeding procedure. There's no vent screw on the injection pump that I can see, so I loosen the banjo bolt on the pump's outlet. Fuel runs out by gravity with a few bubbles from the filter, then I crank it by hand with the decompression lever held down until the fuel comes out steadily. Then I do the same at the injector until fuel comes out the top of it. It still doesn't start on the crank handle this time, but the fuel is through. Adrian's view is that after five or more years sitting, the fuel can go waxy inside the injection pump, so it may need more work there.

Finding an air leak

A workboat's engine stalls at idle after it has been running an hour or more: it idles for five minutes, then winds down. Adrian's trick: put the return line in a bucket and watch for bubbles while the engine runs. They appear as the revs come up, so we tighten the fittings before the pump and on the Raycor filter, and talk through how air collects in the filter. Any air sucked in before the pump goes all the way through. It's a theory to test rather than a sure fix.

Priming the Detroit

With the rebuilt Detroit Diesel back in Renko, I put a primer bulb in line between the tank and the filters, open the bleed valve on the filter until fuel comes out, then keep priming until it comes out of the return line. The Detroit's unit injectors bleed themselves, but only once they have fuel pressure. See also diesel fuel filters.