Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

A four-stroke's valves have to seal against their seats in the cylinder head. When they don't, through carbon build-up, wear or damage, the compression is low on that cylinder. Fixing it means taking the head off, removing the valves and cleaning and lapping them, or having the head machined, then putting it back together with new valve stem seals.

In this video a Honda head has come back from being machined after water got into the bottom cylinder. I fit the valves with pre-assembly grease, new stem seals and the springs, using a spring compressor to get the collets in. Then the fuel pump pushrod, camshaft and rocker assembly go on, and I set the camshaft to top dead centre on cylinder one ready for the head to go back on. These valves were machined to an interference fit rather than lapped, so they bed in as they run. That's why I set the valve clearances a thou or two wide once the head is on, then check them again after a run.

Putting the head back on

Refitting the head on the Yamaha 50HP. The tightening order is numbered on the head, starting from the centre bolts and spiralling out, and they're torqued in two stages: the 9mm bolts to 23 then 47 Nm, and the 6mm bolts to 6 then 12 Nm. One bolt had been repaired with a helicoil before and just spun, so I bought a new bolt and had to drill the gasket for it. I move the dowels across to the block, fit the cover with a new seal, then refit the camshaft sprocket and timing belt with both marks at top dead centre.

Cleaning and lapping the valves

On a Yamaha 50HP four-stroke, I put transmission fluid in the cylinders as a rough leak-down test, then take the valves out with a spring compressor. I clean the carbon off them, clean the head, check it isn't warped with a straight edge and feeler gauge, and lap the valves with coarse then fine paste. Cylinder 1's exhaust valve had the worst seat, which explained its low compression. Cylinder 2 drained its fluid fast, pointing to rings instead.

Removing the cylinder head

Taking the head off the same Yamaha 50HP. I remove the carburettor and intake assembly, flywheel and stator, set it to top dead centre on cylinder one and take off the timing belt. Then the valve cover, rocker assembly, oil pump and camshaft come off, and I undo the head bolts in a spiral from the outside in.