A DC-DC charger charges one battery from another: a 12 volt battery from a 24 volt bank, a lithium bank from the alternator's starting battery, or a separate battery like a bow thruster's. Unlike a voltage-sensitive relay, it controls the charge, so it suits lithium batteries and protects the alternator. It decides when to charge from its input voltage, which you set in its app.
In this video I fit a new 24/12 charger on Renko, after reversing the polarity on the old one. The terminals don't run positive, negative, positive, negative: they go positive, negative, negative, positive. This time I remove the remote-off jumper so it's off while I wire it, check the order twice, then put the jumper back. In the app I set it to start charging when the 24 volt lithium bank is above 25.6 volts and stop below 25, so when the solar is charging the 24 volt bank, it charges the 12 volt battery too. Make a note of the Bluetooth PIN and PUK code.
A blown fuse
On a 40 ft catamaran the bow thruster's 12/12 charger had stopped. The midi fuse behind its switch panel had blown: it was a 30 amp fuse on a 30 amp charger, and Victron recommends 60 amps. With a 60 amp fuse it works, and the app shows its input voltage dipping, which I trace to dead house batteries.
Charging lithium from the alternator
Renko's DC-DC chargers in 2021. A Redarc 24 to 12 volt charger keeps the 12 volt house bank charged from the 24 volt bank, and an Orion replaces the old VSR between the starting bank and the lithium house bank. A flat lithium bank can take so much current it looks almost like a short circuit to the alternator, and can burn it out. With the Orion, the alternator charges the starting bank and the Orion charges the lithium in a way that suits both.
