An inboard engine sits out of sight in the engine bay, so the gauges and alarms at the helm are how you find out something is wrong before it does any damage. Each gauge needs a sender on the engine, and an alarm is only useful if you know it works.
In this video I fit Renko's instrument panel. A flow alarm sender goes in the raw water line, to sound if no cooling water is flowing through the heat exchanger. At the dash, the sender wires for the tacho, oil pressure and coolant temperature come through the multi-core to a terminal block. One switch powers all the gauges, and I treat it like an ignition switch: turn it on and the flow alarm sounds until the engine starts and the water flows, so it tests itself every time without going off while the engine's stopped. I also fit three bilge alarms, for the cabin, engine bay and lazarette, on float or field effect switches. Later in the video I fit the coolant temperature sender in an adapter machined so the coolant flows right around its tip.
A Murphy temperature sender
Fitting the sender for a Murphy temperature gauge to Renko's engine, with a thread adapter and thread sealant, taking care not to crack the water jacket.
Setting the alarm contact
A Murphy gauge has a contact you move with an Allen key. When the needle touches it, it sets off the alarm, but it also stops the needle, so you can't see how hot it would have got. We set the temperature one at about 100 degrees, and the oil pressure gauge works the same way for low pressure.
A mechanical oil pressure gauge
I replace a cheap electric oil pressure gauge with a Murphy mechanical one, on a nylon line with an olive fitting. Once it has bled itself it reads 10 psi higher than the electric gauge ever did, and agrees with the mechanical gauge on the block.
