Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

The forward control is the box at the helm with the gear and throttle lever. Inside are the detents that click it into neutral, the fast idle, a friction adjustment, and usually the ignition switch, kill switch lanyard and warning buzzer too. When the lever sticks, won't stay put or won't leave neutral, the fault can be in here rather than in the cables.

In this video I strip down a Honda forward control that had been lying in the workshop full of mud. You only need the bottom plate off to change the control cables. Further in, I show the detent that gives the click into neutral and stops you selecting a gear with the fast idle up, the nylon bushings that wear, the friction screw, and the switches, which are simple plug-in replacements. This one has no start-in-gear switch, but many do. I finish with tips for getting it back together.

Fitting a new control on Renko

In this video I swap Renko's single-lever control for a separate throttle and gear lever, because it has a locking throttle for cruising. The old cables come off, the new control sits on a little plinth I made, and I set up each cable on its own. I want the throttle to pull its cable as I push the lever forward, and I pick the hole that gives the most travel, since the old control ran out of lever before the governor reached full fuel. For the gear cable, the holes give 20, 27.5 or 35mm of throw, and the inner one is enough to get a gear. Then I adjust the cable end so the gearbox clicks into its detent.

Reversing a Yamaha 703

On a 1980s Yamaha that needs a throttle cable that pulls instead of pushes, I reverse a Yamaha 703 forward control by swapping in the throttle linkage from the worn-out control that came with the motor. Without a spare, you could grind off the peened pin and move the linkage to the other hole. Then I find the gear cable still won't fit: the cable clamp plate in the lower cowling is a newer design than this motor, a gotcha when you build an outboard from mixed parts.