Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

To replace leaking seals, worn gears or the dog clutch, the gearbox has to come apart. In this video a Johnson 30HP lower unit was leaking, so I take out the bearing carrier, making a puller for it, then the prop shaft and gear train.

Getting the bearings out

Then every bearing comes out of the Johnson, without the factory special tools. A spigot bearing puller takes out the top oil seal and the rusty driveshaft bearing. I grind a slide hammer tip thinner to get behind the forward gear's bearing race, drive the two lower driveshaft bearings down into the gear case with a 19mm socket, pull the shift linkage bushing with threaded rod and the slide hammer, then get the bearing carrier's bearings and seals out.

Fitting new bearings

The spacers that set the pinion bearings at the right depth are discontinued, and the service manual doesn't give the depth. I drive in the forward bearing race, sit the pinion and forward gear in place and measure down to the pinion, then use the witness marks on it to work out the bearing depths: 132mm and 162mm from the top of the gearbox. Washers and a bit of pipe make up the spacers to press them in to.

Putting the Johnson back together

The prop shaft, dog clutch and gear selector go back into the Johnson's gearbox, with a Sierra lower unit seal kit.

The bearing carrier and a pressure test

The two prop shaft seals go into the bearing carrier back to back, springs facing away from each other, pushed in with a 23mm socket. Then a new O-ring, the reverse gear thrust washer, and the retaining plate and its circlip in the gear case. A bolt with its head cut off lines the carrier up with the plate's threaded holes as it goes in. After the driveshaft seals and the driveshaft, I pressure test it, and it holds at 10 psi.

Removing the driveshaft

On a Yamaha gearbox, I take off the water pump, free a stuck woodruff key with heat, pull the oil seal housing and bearing carrier, undo the pinion nut, and take out the driveshaft, pinion gear and forward gear. I also show how the dog clutch and gear selector work.