Merch
PayPal
AmazonThis topic covers a variety of reasons that an outboard motor can be hard to start. If your engine is always hard to start when hot or cold, the first two options will give you information specific to those two situations.
PHOTO Dangar Marine Boat Guide
Outboard motor is hard to start from cold
Open ›
It is most common for outboard motors to be hard to start when they are cold and have been sitting for a long time.
The outboard is hard to start again after running
Open ›
Once the outboard is warm from running, it's reluctant to start again. I go through the several possible causes, including a flooded engine, so you can work out which one applies.
The outboard has faulty reed valves
Open ›
Only two-stroke motors have reed valves. These are one-way valves that stop the air and fuel mixture coming back out from the crankcase.
The fuel tank breather vent is closed
Open ›
Fuel tanks need a way to let air in and out of them as the fuel level changes. This is the job of the fuel tank breather.
The fuel in the tank is old and has gone stale
Open ›
Petrol doesn't last forever. It is generally considered to be too old by the time it is about 6-12 months old, unless treated with an additive.
One or more cylinders has low compression
Open ›
In order to run and start the pistons must be able to compress the air drawn into the cylinder sufficiently to get the correct air to fuel ratio needed to start and run.
The carburettor has debris blocking the jets
Open ›
A very common reason that outboard motors run badly is from dirt in the carburettor(s). This can be from water or other contaminants in the fuel, perished fuel lines breaking up and putting debris into the fuel or varnish from fuel that has evaporated after the engine has been sitting for a long time.
The fuel primer bulb
Open ›
The primer bulb pumps fuel from the tank to the fuel pump, which can't pump air. I cut one open to show its one-way ball valves and why holding it arrow up helps it prime.