A hydrofoil is a wing that bolts onto the outboard's anti-ventilation plate. They're sold to get a boat on the plane sooner and flatter, reduce bow rise and porpoising, and help with ventilation, where the prop sucks down air (see the propeller).
In this video I fit a Stingray Classic to the Green Machine's 40HP Honda. First I take the boat out and trim the motor up until it ventilates, in a straight line and in turns, and mark the leg so I can compare. Then I line the foil up on the anti-ventilation plate, drill it and bolt it on with the rubber washers and nylocks. Back on the water, the boat stays much flatter as it comes onto the plane, and the ventilation in turns comes and goes rather than letting go all at once, but I can't trim much higher. It also works as a guard that stops the prop hitting piles. The boat didn't have a problem to start with, so if yours runs fine there's not much point. If it porpoises or runs at an angle, a foil may be worth trying. If it ventilates even trimmed all the way down, it probably needs a longer shaft or mounting lower.
