An inboard's marine gearbox sits between the engine and the prop shaft, and it relies on its oil and oil seals like any gearbox. Water in the oil, a leaking seal or a lack of oil can all stop it, and a gearbox that runs low on oil gets hot enough to smoke and then loses drive.
In this video Renko's gearbox had emulsified oil. Water could have come in through the oil seals, the oil cooler, or a snapped-off oil temperature sender. I take off the output flange, held on by a castellated nut, and pry out the first seal, then check the input and output bearings for play (there was none, so they stay) and punch out the second seal and its housing. I take the seals, the housing and the flange to a bearing shop to match them with aftermarket seals, and measure the shaft as well. Their tip: buy a cheap seal and swap its mild steel spring for a nitrile O-ring, so it won't rust.
Fixing the cause
The rebuilt gearbox from Dave's boat, Delstar II, which overheated on the trip down the coast. Jason, who rebuilt it, explains that in this gearbox only the oil left over after a pressure relief valve went to the cooler, so if the valve didn't open, no oil was cooled. He modifies them so all the oil goes through the cooler before the valve body, which also shows up any leak straight away.
Overheating at sea
Bringing Dave's boat, Delstar II, down the coast, after about six hours of running we smell burning, and smoke is coming off the gearbox. The oil is nearly all gone, and the boat loses drive until we top it up. Pour the oil in slowly: hot air trapped behind it can blow hot oil back out. Checking the gearbox regularly with an infrared thermometer would have shown the temperature creeping up long before it smelt.
