Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

Beyond the usual spanners and screwdrivers, working on outboards takes some specialist tools, and the most important of all is the service manual for your motor, for the specs. If you only work on your own outboard you only need one of each. Working on lots of brands, the list grows quickly, and some makers' tools are hard to buy at all.

In this video I go through my toolboxes. For engines: a timing light, a mechanic's stethoscope, a remote starter, a spark tester, thin-walled spark plug sockets, feeler gauges and a compression tester. For electrical work: a multi-function auto tester, test light, multimeter, wire strippers and crimpers. Then the outboard-specific drawer: a gearbox pressure tester, a brake hone for tilt tubes, face spanners for trim/tilt caps, pliers for wire hose clamps, a pinion nut holder, pullers and bearing carrier pullers. I also show tools I've made: an old driveshaft that holds the crankshaft still, a long socket for the nut under the flywheel, a puller hook from a bent bolt, and a lead for running a trim/tilt motor straight off the battery.

A lower unit stand

I used to hold lower units in a vice by the skeg, which can break it. If you must, drop it as far into the vice as you can, onto the thicker metal and with less leverage. A stand is better. Mine is a U shape the gearbox drops into, with the anti-ventilation plate resting on top. Measuring a small and a big gearbox, it had to be wider than 60mm and narrower than 120mm, so I went with 80mm, and 500mm long. I cut 50mm steel box section with 45 degree mitres, tack weld it, check it's square and weld it out, add an arm to hold in the vice, then rivet on strips of polyboard, countersunk so the rivets can't scratch the paint. Timber, or steel bolted together, works just as well; the dimensions are what matter.

An outboard stand

The first project on the channel was a stand to hang an outboard on in the workshop, built from timber I had lying around. The upright the outboard clamps to is tilted back about 15 degrees. I show how to notch timber with a circular saw set to depth and a chisel, then glue and screw the frame together. Clamp the pieces tight first: if the gap sits halfway along the screw's thread, the screw can't pull them together. Castors underneath, with brakes on the two swivelling ones at the back, make it easy to move. The uprights are about a metre, the transom 600mm wide and about 1170 to 1200mm off the ground, and the base pieces 1100mm.