When a two-stroke has worn rings, scored bores or a hole in a piston, the powerhead comes apart. The block may need re-boring for oversized pistons, and everything goes back together with new bearings, seals and gaskets. The work isn't complicated, but the parts have to go in the right way round and nothing should ever need forcing.
This is the Evinrude 150, back from the engineer with its bores machined and new pistons, in the order I put it together. In this video I assemble the pistons, which are made for each bank and have to face the right way. I fit the needle rollers to the little end with assembly grease, put in the wrist pin and its clips, check the ring gap in the bore and fit the rings.
Fitting the pistons
I clean the old RTV out of the water passages and clean the bores, fit new seals to the cylinder heads, then slide the pistons in with plenty of two-stroke oil and a ring compressor. Then the cylinder heads go on with RTV and are torqued in stages.
Installing the crankshaft
New crankshaft seals, then the crankshaft goes in with its bearings locked onto their dowels. I fit the conrod caps until I can't feel a ridge with a fingernail and torque them in stages, then seal the crankcase with Loctite 518 and torque it down.
The first start
With fresh fuel mixed 50:1 in an external tank, I reseat a distorted carburettor bowl gasket that was pouring fuel, crank it with the spark plugs out and the lanyard off to listen for any bad noises, then put the plugs in and start it. All up, the re-bore and pistons cost about $2,500 and the gaskets, sealants and bits another $500, against a perfectly good 150HP.
Running it in
Before its first sea trial I swap the NGK-equivalent spark plugs for the original Champions and set the carburettor mixture screws to the factory 5¾ turns out: wind each one in gently until it seats, then back it out. The manual's break-in is 10 minutes at a fast idle, then 50 minutes between idle and 3,500 revs, changing the revs as you go. I keep an eye on the telltale and the head temperature, and mark the oil tank to check the VRO pump is picking up oil. For the next 8 hours, get it up on the plane then back it off, with no long runs at full throttle.
Honing the bores
On a Yamaha 40HP two-stroke that was sunk and run without oil, I clean the bores with a little hydrochloric acid to remove any aluminium from a scored piston, then hone them with a ball hone to get rid of the rust and put back a cross hatch.
