Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

Bolts break when they're corroded in, or when they're overtightened, and a steel bolt in an aluminium block can strip its thread. A broken bolt turns a five minute job into a long one, so it's worth knowing which technique suits where it has broken. A broken spark plug has its own page.

In this video I snap some bolts in an old engine block on purpose and show how I get them out. A rounded-off head comes out with a socket made to grip it, and a shank sticking up comes out with vice grips. If it's broken off flush, I weld a nut onto it with a stick welder, or drift it round with a sharp chisel. Below the surface, I drill down the centre using a drill guide and use the largest easy out that fits, going up a drill size if there's still plenty of bolt left. Drill deep enough, or the tapered easy out bottoms out and just spins before it grips. Easy outs can break, and a broken one is very hard to get out, so know when to stop. One of mine wouldn't budge, so I explain the last resort: drill the bolt out completely and repair the thread.

Drilling right through

Three rocker cover bolts broke on the keel-cooled outboard. Where there was nothing behind them, I took an engineer's advice: drill right through and use a longer bolt with a nut. On the other side I couldn't, so I put a thread insert in.

Repairing a damaged thread

When a thread has stripped, or a bolt had to be drilled out, you can drill and tap for a bigger bolt, but that means a different head size and uneven clamping. A thread repair kit puts the original size back. Using a Würth Time-Sert kit on an exhaust cover hole, I drill out the old thread, countersink, tap, and wind the insert in with the tool, which locks it into the block.