The powerhead has to come off the leg to split the crankcase, replace the crankshaft seals, rebuild the engine or get to a seized pivot tube. The job is mostly finding everything that connects the powerhead to the leg, the lower cowling or the boat, and undoing it, then undoing the bolts underneath and lifting it off.
In this video I'm making one good outboard out of two Tohatsu 9.8HP two-strokes, one with a blown head gasket and one with a seized pivot tube, so I take the powerhead off both. I disconnect the throttle and gear selector cables, the kill switch wires, the choke and the fuel line, then undo the three bolts each side underneath. When a powerhead won't lift, I take the gearbox off to check the driveshaft splines aren't stuck in the bottom of the crankshaft. Both times the splines were well greased; the first powerhead was just stuck and came off with a few taps.
A two-stroke run without oil
With Lorenzo, taking the powerhead off a Yamaha 40HP two-stroke that died after being run without oil in the fuel. The gear selector stays with the lower cowling and the driveshaft stays in the gearbox, then the gearbox comes off so the rest is light enough to carry.
A Yamaha 50HP four-stroke
With the flywheel off, I disconnect the wiring plug, throttle linkages, fuel lines, battery leads, trim/tilt relay and cables, gear shift linkage and telltale hose. Then I rig it to a crane, undo the six bolts each side underneath and lift it off.
