Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

Every hose that takes water in or out below the waterline goes through a skin fitting in the hull, with a seacock (a valve) on it so it can be shut off. If one fails the boat can sink, and if one blocks, the engine's cooling water stops. These are from the refit of Renko, my steel trawler.

In this video I build up a corroded hull flange with weld and grind it flat, then install TruDesign composite skin fittings below the waterline. I explain why I'm happy to use them instead of bronze: no corrosion or dissimilar metal problems, and they meet the ABYC load test. I check the hull thickness and thread length, bed the fittings in Sikaflex, then fit the load-bearing collars, ball valves on Teflon tape, and hose tails with T-bolt clamps. Then I pack the stern gland.

A blocked seacock

After the Hawkesbury River flood, Renko's engine kept overheating. With nothing blocking the raw water strainer, heat exchanger or pump, we find the seacock itself is blocked: open, almost no water comes in. Pete clears it, and that solves the overheating.

Preparing the holes

Getting the holes in the hull ready for the new fittings: cleaning them out with flap wheels so the fittings fit, grinding off old bolts, and treating the rust before epoxy primer. I also talk about going from metal gate valves and pipe to plastic ball valves and hose.

Servicing gate valves

Renko's old gate valves were seized and full of oyster shell. A soak in white vinegar dissolves the shell, then heat and two hammers free them. I take one apart, clean it on the wire wheel, put it back together with anti-seize and repack the valve stem.

Removing the old seacocks

In this video I take Renko's old bolted-flange seacocks out from inside the hull. The nuts are underneath and the impact gun won't fit under the flanges, so I undo them by hand. Gussets stop a spanner reaching the last bolt, so I take the other three out and rotate the valve round to get to it. One valve had oysters growing inside, no wonder it wouldn't move. I also work out what each one fed, and which I can blank off.