Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

An outboard that has been under water, especially salt water, needs attention quickly, before the corrosion sets in. Get the water out of the cylinders and oil into them, then work through the fuel and electrics.

In this video a 15HP Yamaha two-stroke has sunk in salt water. I oil the cylinders with penetrating oil, clean and charge the corroded battery, turn the motor over, then take the carburettor off and clean it, clean the fuel filter and fuel pump, and get it running.

Flushing it out

An outboard off a punt that sank: flushing it out.

Losing spark after a sinking

A Johnson that sank in a storm was running again, but the next day its spark kept dropping out. Water had got into the wiring loom plug, and the black and yellow wire stops the motor by grounding the ignition, so a soggy plug was leaking the spark to ground. Disconnecting that wire made the spark strong again. I put spade connectors on it, so the motor can be run and dry out while the plug dries, and stop it by touching the wire to the crankcase.

A sunk Honda BF40

A 2004 Honda BF40 four-stroke that sank, bought for $200. Here I finish getting it going again: the carburettors and fuel filter, the starter motor, the forward control, pressure testing and refilling the gearbox, fresh engine oil, and its first start.