Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

A boat trailer's hubs go into salt water every time you launch, and the bearings inside them are what you're relying on at 100km/h on the freeway. Check for play: a hub should turn, but you shouldn't be able to rock it up and down or side to side. Even a slight wobble means something's up with the bearings.

In this video I change the bearings on one wheel of a trailer with disc brakes, from jacking it up to checking the job at the end. I take off the bearing buddy, the brake bracket and the castellated axle nut, then measure the axle to pick between the Holden type bearings (39mm axle) and the Ford type (45mm). This one's Ford. Make sure you buy marine bearings for a boat trailer. One old race was the most stuck I've ever seen, and it took heat to get it out. I drive the new races in with the old ones, thick edge down so the old one can be punched back out, pack the bearings with grease, fit the new seal, and set the nut so the hub turns freely without play. If you haven't done this job before, get someone who has to check your work, and take the trailer for a short, slow run before a long trip.

Jockey wheels seize up too, so they won't wind up and down or the wheel won't turn. I take one apart by knocking out the roll pin, cut open one that's too far gone to see how it works, then clean and grease a newer one and put it back together.