Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

Before looking at boats at all, be clear what you'll use it for and who'll be on it: commuting, fishing, skiing, just you or the whole family, young kids or older people. A boat that isn't fit for purpose is no bargain, however good it is.

In this video I go with Paul to look at a second-hand aluminium runabout. He brought a checklist, a compression tester and spark plug tools, and asked the seller beforehand whether he could do those tests. We check the hull for pitting and for cracks where the ribs meet the chine and keel, the builder's plate against the outboard's horsepower (rated for 100HP, with a 90HP Yamaha two-stroke on it), the anodes, the trailer and the steering yoke, often the only mild steel part of the outboard, then do a compression test. On a four-stroke, check the oil isn't low and has no water in it, ask the owner about the boat's history, and check the trailer's wheel bearings before you tow it home. We didn't film Paul's test run, so on a similar boat with a 90HP Mercury four-stroke I go through what to look for on the water: how stable it is, water coming into the bilge, how it starts, idles and accelerates, whether it gets close to the motor's red line (about five to five and a half thousand rpm here) at full throttle, and how it rides. Finally, check there's no money owing and it isn't stolen, write a receipt, and pay with a bank cheque.

Ten tips for an old boat

Looking back on buying and restoring Renko: always be prepared to walk away, have the boat inspected out of the water before you buy (a $2,000 inspection would have saved me $30,000 of repairs), only value the accessories you actually want, and buy the best boat you can afford rather than a cheap one to do up.

Choosing a project boat

Choosing an old boat to work on: does it fit what you want to use it for, do you have somewhere affordable to work on it, and can you do the work there. The purchase price is the smallest part of the budget, a free boat isn't as cheap as it sounds, and it's worth picking a material you're comfortable working with.

What an old boat really costs

There's no such thing as a cheap big boat: you either buy an expensive one or buy a cheap one and spend a lot on it. In this video I add up Renko's restoration in Australian dollars. The hardstand was ten grand, which doubled the cost of the boat straight away. Sandblasting was about $2,500, anodes about $500, the rudder post, prop shaft and stern gland about three grand, the engine about another 10 grand and the gearbox rebuild about three. Then come the electronics, batteries and solar, skin fittings, and the endless small stuff. All up it was about 10 to buy and at least another 50. In hindsight I'd have paid for an inspection out of the water, and at least taken the rocker cover off the engine. Sharing the boat with partners keeps your own cost down.

Buying a big timber trawler

In this video I ask Dave how he came to own his 38 tonne timber trawler. He looked for seven years, and when this one came up in Victoria he had it pulled out and spent eight hours going over it from bow to stern. He runs its Detroit Diesel at its sweet spot, about 1270 rpm and 13 to 14 litres an hour. The first question is what you want the boat for, and his advice is not to buy a really old timber boat unless you're a shipwright.