Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

A four-stroke's crankshaft has an oil seal at each end, one under the timing belt pulley at the top and one at the bottom where the driveshaft goes in. On both motors here, changing the lower seal means taking the powerhead off and splitting the crankcase, which turns a simple seal into a big job. On a two-stroke a bad crankshaft seal lets air in instead, see vacuum leak.

In this video a Yamaha four-stroke had a big oil leak, so with the powerhead off we split the crankcase to replace the lower seal, which has a lip that stops it sliding out. Before fitting the new seal we put a repair sleeve on the crankshaft so the seal has a smooth surface to run on. Most of the oil was actually coming from a corroded oil passage beside the raw water outlet, so I weld that up and pressure test it.

On a Yamaha 50HP four-stroke I make a tool from an old driveshaft to hold the crankshaft, take off the timing belt pulley and fit the new top seal. The new bottom seal turned out to be the part for a different year, so I refit the old one, whose running surface was still good. Then the crankshaft goes back in, and I seal the crankcase with Loctite 518 and torque it up in the order printed on it, in two stages.