Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

The power trim and tilt unit is held between the clamp brackets by two pins. To service the unit, replace it, or get to the swivel bracket behind it, those pins have to come out, and on an outboard that lives in salt water they're often seized. If only the electric motor has failed, see replacing the trim/tilt motor instead.

In this video I put the unit back on the Yamaha 50HP four-stroke. I cut the old, brittle nylon bushings out with a hacksaw blade, clean and grease the holes and press in new ones. The main pin goes in from the side where its hex head sits in a recess, and with the motor laid flat I line up the holes and use the thread to pull the pin through the tight new bushings. Then I refit the anode leads, check the reservoir is full of automatic transmission fluid, and test it straight off a battery by swapping the polarity on its two wires.

Taking it off. With the motor tilted up and the tilt support down, I drop the gearbox, finding a hidden bolt under the trim tab anode, then take out the top pin, whose circlip had rusted away. The bottom bolt was badly seized, so I lay the motor on its side and use penetrating oil and a hammer, with the nut back on to protect the thread. All this was to get to a seized pivot tube.