A perspex windscreen panel can be smashed by another boat in a storm, or just crack with age. Getting the old pieces out of the frame can be easy or hard, depending on whether it's screwed, riveted or siliconed together, but the new panel then has to be cut to shape and bent to the curve of the frame.
In this video Dave and I replace a panel in his boat's windscreen. We glue the broken pieces back together and trace them onto thin ply to make a template, and a perspex shop cuts the new panel from it. To bend it, we try a test piece first. The perspex shop said it needs to get to about 100 degrees, and a barbecue gets it soft enough without melting it. The old panel was flat at each end, so only the centre goes over the heat, with the outside of the curve towards the heat, and we feed it into the frame while it's still warm. To fit it, the U-shaped rubber goes onto the perspex, detergent on the outside helps it slide into the bottom channel, and it gets a few taps to go in. Our template was a little long, so we grind back the end so the end cap fits.
