Aluminium boats get holes from corrosion and cracks from knocks and stress. A riveted patch needs only simple tools, while welding aluminium takes more gear and practice. Before you fix a hole, work out what caused it, so the repair doesn't make things worse. To find where the water is coming in first, see finding a leak.
In this video I fix two corrosion holes in the transom of an aluminium boat without welding. They were around stainless steel bolts, which reacted with the aluminium. I clean the area back to bare metal, cut a plate to fit using a paper template, then rivet it on over a bed of Sikaflex with aluminium blind rivets, dipping each rivet in sealant first. The plate holds the sealant in place and protects it. For a single pinhole, a rivet dipped in Sikaflex on its own does the job.
Stick welding aluminium
I try aluminium stick welding rods with a small, cheap welder, which is easier to take down to a boat on the beach than a TIG welder and argon. It's hard to hold an arc and the rods burn very fast, but after practising on scrap I weld a rib back into the boat. It's a skill that can get you out of trouble in the field.
TIG welding a crack
I explain the oxide layer on aluminium and how AC TIG welding clears it, sharpening tungstens and managing heat with tacks. Then I use dye penetrant to find the full length of a crack on the chine, drill a small hole at each end to stop it spreading, and weld it up. If a crack keeps coming back from normal use, add some bracing there.
