Home
Guide
Map
Ask Eddie
Search
Reference
Forum
About

The tow eye on the stem of a boat isn't just for winching it onto a trailer. On a moored boat, the bow ropes all attach to it, so it's working every time the boat rocks in the waves. An aluminium tow eye is softer than the steel shackle through it, and over the years it wears thin.

In this video the Green Machine's tow eye, a plate of aluminium about 10mm thick, has worn too thin to trust. I cut it off and flatten the stem with a flap disc, leaving some of the weld as a flat pad, then mark, centre punch and drill a pilot hole before stepping up to 10mm. The new stainless U-bolt goes in on a bed of sealant similar to Sikaflex, in the holes and under the flange. I let the sealant firm up before tightening, so it stays as a bed instead of squeezing out, then fit the backing plate, Loctite, spring washers and nuts from inside the bow.

Stainless steel and aluminium react with each other, especially below the waterline, so whenever you put them together, keep them apart with a good bed of sealant or a coat of Duralac, or the aluminium will corrode. There's more on repairing an aluminium hull.